How to Root and Install TWRP Samsung Galaxy J7 Prime 2 - SM-G611F.

Root Samsung J7 Prime 2. The following guide will show you how to Root and install TWRP recovery on Samsung Galaxy J7 Prime 2 device. In some mobile manufacturers have set root will avoid the manufacturer's warranty. Nevertheless, you get a lot of advantages while rooting your device. because you will get total control over the entire Android system. Your device may able to download and use all the blocked features, APK, and tools. Although there are many advantages that you get after the root of your device. Actually, the root will open the blocked features and tools needed to protect you from malware or any other risks. So, if your device is rooted your device will never be protected.

Ok, here I think you already understand what the advantages and disadvantages in doing root. So, you are ready to root on the Samsung J7 Prime 2 device. and ready to follow the current guide.

Ok, now let's start to root Samsung Galaxy J7 Prime 2 now.

root Samsung J7 Prime 2

Prerequisite.

1. Make sure to enable developer options.
2. Then, enable OEM to unlock.
3. Now, enable USB debugging.
4. Set USB settings as DM + ACM + ADB
• How to set the USB settings on Samsung Galaxy J7 Prime 2?
• From standby, dial *#0808#
• It will access the USB Settings menu.
• Now, select DM + ACM + ADB
5. Now, d0wnload ODIN from here.
6. Then, you need TWRP recovery that will be installed on your device. You can get the TWRP for your J7 Prime 2.
7. Now, you need SuperSU which we will use later to root our device. SuperSU can be taken from the following link. As additional information, we are using SuperSU version 2.82.
• Copy SuperSU to flash disk and then connect your flash disk to your phone using OTG.

Guide to Root Samsung J7 Prime 2.

To continue the Root process, make sure all the files on the prerequisite above you have prepared. Now, follow step by step instructions below to start this guide.

1. Enter your device into Download Mode. How to enter Samsung Galaxy J7 Prime 2 into download mode? Press and hold the following button at the same time.

• Volume Down + Home Button + Power Button.

• Release all button when your phone showed a Warning screen.
• Continue to enter download mode, you can press the Volume Up button.
• Otherwise, you can press the Volume down button.
2. When your phone show Downloading connect it to the computer via USB cable.
3. Now, go to the computer desktop.
4. Run ODIN software.
5. Make sure your phone successfully connected, this is indicated by the port number that appears on the ID: COM.
6. From the ODIN window, now click the AP button. Then, navigate to the drive where the TWRP file is stored
7. Once it ready, now click the Start button on ODIN window.
8. Just wait for the process until done, the phone will automatically reboot.
9. Now, Power off the phone.
10. Then, Turn on again and boot your device into TWRP recovery. How to boot Samsung Galaxy J7 Prime 2 into TWRP recovery? Press and hold the following button simultaneously.

• Volume Up button + Home Button + Power Button

11. Once your phone enters TWRP menu, swipe to the right to allow modifications.
12. Then on the TWRP main menu select Wipe and swipe to the right to confirm.
13. Tap back and format data, then type yes to confirm.
14. Now connect the flash disk that already contains the SuperSU file to your device using the OTG.
15. Then, select install.
16. Navigate to USB OTG which already contains Supersu file
17. Select the file and swipe to the right to install it.
18. Just wait for the installation process until done, the phone will automatically reboot.
19. Finish.

Share this post